How to avoid the failure of scrap iron shredder equipment

The main purpose of the scrap iron shredder equipment is to cut various unqualified scrap iron scraps into small pieces for recycling. Reduce the amount of raw materials mixed with other materials.

First, when inspecting and cleaning, the machine should be cleaned in time after the end of each day and checked for loose screws and worn parts such as claws, screens, etc.

Second, add grease in time, usually the oil cup is assembled on the bearing. Generally, as long as the oil cup cap is rotated 1/4 times every 2 hours, the grease in the oil cup will be pressed into the bearing. For closed bearings, grease can be added every 300 hours. After long-term use, if the grease deteriorates, clean the bearing and replace it with a new one. When the machine is working, the bearing temperature should not exceed 40 ° C. If the bearing temperature continues to rise under normal operating conditions, the cause should be determined.

Third, do not increase the speed of the scrap iron shredder at will. Usually, the difference between the speed and the rated speed is between eight and ten percent. When the scrap iron shredder is working on a high-power machine, care should be taken to control the flow so that the flow is uniform to avoid sudden acceleration or deceleration. In the equipment structure, it is necessary to replace old equipment and damaged equipment in time to greatly increase the utilization rate. At the same time, automatic synchronization management of production lines is established, which saves time and facilitates production.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。