Some reasons affect the abnormal vibration of the shredder

Large-scale shredder is a mechanical equipment for processing large materials. The waste materials processed by the shredder not only improve the utilization of resources, but also reduce the waste of raw materials. However, it is inevitable to encounter failures when using the shredder. Many friends are concerned about the vibration of the shredder. What's going on?

1. If the discharging speed is too slow during production, the motor load will increase significantly, and the ammeter pointer swings deviating from the quota parameter, which can be determined to be equipment blockage caused by the too fast feeding speed. When this happens, you should immediately adjust the speed of the feeding mechanism, slow down the feeding speed of the conveyor belt, and wait until the machine returns to normal operation before starting the fixed feeding. During this period, you should pay attention to the ammeter pointer and control it with 85% of the rated current as the standard to solve the above problem. .

2. The discharge pipe is not smooth or blocked. Feeding too fast will block the air outlet; improper matching with the conveying equipment will cause the discharge pipe to be blocked after the wind is weakened or there is no wind. After the fault is detected, the unmatched conveying equipment should be cleared at the delivery port and the feed amount should be adjusted to make the large shredder operate normally.

3. The hammer head wear is serious and the aging phenomenon is obvious. The blocked aperture of the screen mesh will cause the output of the large-scale shredder to decrease when it is working and cannot meet the feeding needs, causing the equipment to be blocked. In such a situation, the hammer head should be replaced in time to remove the screen mesh. Carry out hole cleaning to keep the large shredder in good working condition.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。