What should be noticed when operating the shredder

What should be noticed when operating the shredder?

1. Always check the connecting bolts, especially the square head bolts that fix the toothed plates to prevent loosening.

2. Each class is lubricated 1-2 times for each bearing bush, large and small gears and special-shaped gears to ensure sufficient lubricating oil inside the bearing bush to reduce the excessive decomposition loss of the sleeves and gears.

3. The feeding particle size should not exceed the specified size, and the feeding should be continuous and uniform to prevent the phenomenon of blocking.

4. Always check the temperature of the backup bearing. The temperature rise of the bearing bush should not exceed room temperature 25-30℃.

5. The bearing slide of the moving roller should be cleaned frequently to remove dust and miscellaneous materials, and prevent the material from entering the moving roller and cannot move and cause an accident.

6. When the power is suddenly turned off, the power of the motor must be disconnected first to prevent accidental accidents. The unshredded material in the shredder is then removed to prevent the shredder from cutting off the safety pin due to excessive load during startup.

7. Pay attention to the working condition of the safety pin at any time. It is found that the power supply should be cut off immediately after the safety pin is cut off to prevent the large pulley from being idle for too long on the sleeve, resulting in excessive wear of the mating surface and even the phenomenon of holding the shaft and other accidents.

8. Operators must strictly implement safety technical operating procedures to prevent random operation and prevent personal and equipment accidents.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。