Installation process of metal shredder equipment

Metal shredder equipment is a commonly used equipment for processing scrap metal materials. The materials processed by the metal shredder can enter the crusher and eddy current equipment for further processing. Common processed materials include paint buckets, lightweight materials, refrigerators, cars, scrap steel, car shells, metal scraps, etc. So what is the installation process of metal shredder equipment? Today we will take you to learn more about the equipment process.

1. Key points for installing metal shredder frame components:

a: Metal shredder equipment is a device that uses knives to shred materials. Due to the large vibration during production, some pads, such as rubber and other vibration buffering materials, can be placed between the cement foundation and the frame. . After installation, check the level of the rack. The deviation must be controlled below 2mm. Some customers install the main unit of the metal shredder by digging a pit. Whether it is ground installation or digging into the ground, it is more convenient.

b: No anchor bolt installation method. The good operating balance of the metal shredder equipment allows the crusher to operate normally without the installation of anchor bolts. The rubber damping block installed at the bottom of the crusher support can absorb vibration peak loads, thereby reducing the impact of the crusher on the foundation.

c: The metal shredder should be fixed on the cement base. If the workplace is frequently changed, the shredder and motor should be installed on a base made of angle iron to prevent the metal shredder from being damaged by moving back and forth.

2. Key points of horizontal and parallel installation techniques

After the main components of the metal shredder equipment are installed, other equipment can be installed. Usually, the movable method can be used for installation. The crusher and motor are installed on the base made of I-beam steel. The pulley grooves of the main machine and the motor should be consistent, and the outer end faces of the pulleys should be on the same plane. In this case There is a basis for activities. When loading materials, you should stand on one side of the shredder or choose a conveyor to load materials to prevent the rebounding fragments from hurting the face. Do not turn off the machine immediately after work, and let it idle for 2-3 minutes to completely discharge the materials in the machine.

3. After installing the metal shredder, check whether the various parts, equipment and base are firmly fixed. If the installation is not firm, vibration will occur. If things go on like this, the vibration will become more and more severe and the noise will become louder. Therefore, we must pay attention to the fixation of each part during installation. After the installation is completed, the metal shredder must be tested and debugged. The simple method is to let the machine idle for a few minutes. If there is no abnormality, it means the installation has been successful. If it is initially Users need to pay more attention to the abnormal situation and prepare for self-debugging in the future.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。